omron.jpg Automatisation industrielle | Support Technique France
codes_erreurs.jpg
-1008

Détails sur ce code erreur

Erreur constatée :
-1008
Catégorie :
Robot Adept
Auteur :
Jean-ChristopheFernandes
Détails :
The position encoder signal from the specified conveyor belt is sending information that is not phased correctly. The encoder or its cabling may be defective. (Encoder error checking is initiated by the DEFBELT instruction and by enabling the BELT switch while a belt is defined.). Make sure the encoder cable is properly connected. Try to run the conveyor at a slower speed. Contact Adept Customer Service if the error persists.

Logiciel concerné