omron.jpg Automatisation industrielle | Support Technique France

Détails sur ce code erreur

Erreur constatée :
Catégorie :
Robot Adept
Auteur :
Détails :
HIGH POWER has been disabled because a failure (Open Circuit) in the front panel HIGH POWER lamp has been detected. The lamp is probably burned out. This condition is considered a safety hazard. An E-STOP is not signaled. However HIGH POWER cannot be enabled until the lamp is replaced.Replace the HIGH POWER lamp. See the Adept MV Controller User's Guide. Re-enable HIGH POWER as desired.

Logiciel concerné